银河集团www.198.net|中國·BinG百科 NO.1

←

→

10G-CWDM-80KM-万兆波分光模块

采用EML激光发射器件和APD接收器件

全国咨询热线：
0755-86654236 /

联系我们 在线客服

扫一扫关注我们

规格书下载产品详情

产品介绍

产品特性

热插拔SFP封装

双纤LC接口

采用EML激光发射器件和APD接收器件

在单模光纤中传输距离达到80千米

内置数字诊断功能

符合SFP MSA标准

+3.3V单供电电压

符合RoHS 6标准

工作温度范围：

商业级：0 to +70°C

工业级：-40 to +85°C

兼容性强，适用于国内外各品牌交换机

产品应用

万兆以太网

光纤网络OC-192 同步数字体系STM-64

万兆交换机互联

万兆路由/服务器光链接

其他万兆光传输系统

光学参数

Parameter	Symbol	Min.	Typical	Max.	Unit	Note
Transmitter Section:
Center Wavelength	λc	λc - 6.5	1471	λc + 6.5	nm
			1491
			1511
			1531
			1551
			1571
			1591
			1611
Spectral Width (-20dB)	σ			0.3	nm
Side Mode Suppression Ratio	SMSR	30	-	-	dB
Average Optical Power	Pavg	0		+4.0	dBm
Laser Off Power	Poff	-	-	-30	dBm
Extinction Ratio	ER	6.0	-	-	dB
Transmitter Dispersion Penalty	TDP	-	-	3.2	dB
Relative Intensity Noise	Rin	-	-	-128	dB/Hz	12dB reflection
Optical Return Loss Tolerance		-	-	12	dB
Receiver Section:
Center Wavelength	λr	1260		1620	nm
Receiver Sensitivity in Average Power	Sen	-24		-7.0	dBm	1
Stressed Sensitivity (OMA)		-22.1	-		dBm	2
Stressed Sensitivity (OMA)		-21.3	-		dBm	2
Vertical eye closure penalty		2.2	-	-	dB	3
Los Assert	LosA	-30	-	-	dBm
Los Dessert	LosD	-	-	-24	dBm
Los Hysteresis	LosH	0.5	-	-	dB
Overload	Pin	-	-	0.5	dBm	1
Receiver Reflectance		-	-	-12	dB
Stressed eye jitter		0.3	-	-	UIp-p	2
Receive electrical 3dB upper cutoff frequency		-	-	12.3	GHz
Receiver power (damage)		-	-	-7	dBm

Notes:

1.Average optical power shall be measured using the methods specified in TIA/EIA-455-95.

2.Receiver sensitivity is informative. Stressed receiver sensitivity shall be measured with conformance test signal for BER =1x 10-12 .

3.Vertical eye closure penalty and stressed eye jitter are the test conditions for measuring stressed receiver sensitivity. They are not the required characteristic of the receiver.

4.Power budget is defined as the different between the Rx sensitivity and the Tx output power of the interface.

5.Path penalty is intended as the power penalty of the interface between back-to-back and the maximum applied dispersion.

引脚定义

PIN	Logic	Symbol	Name / Description	Note
1		VeeT	Module Transmitter Ground	1
2	LVTTL-O	TX_Fault	Module Transmitter Fault
3	LVTTL-I	TX_Dis	Transmitter Disable; Turns off transmitter laser output
4	LVTTL-I/O	SDA	2-Wire Serial Interface Data Line	2
5	LVTTL-I	SCL	2-Wire Serial Interface Clock	2
6		MOD_DEF0	Module Definition, Grounded in the module
7	LVTTL-I	RS0	Receiver Rate Select
8	LVTTL-O	RX_LOS	Receiver Loss of Signal Indication Active LOW
9	LVTTL-I	RS1	Transmitter Rate Select (not used)
10		VeeR	Module Receiver Ground	1
11		VeeR	Module Receiver Ground	1
12	CML-O	RD-	Receiver Inverted Data Output
13	CML-O	RD+	Receiver Data Output (not used)
14		VeeR	Module Receiver Ground	1
15		VccR	Module Receiver 3.3 V Supply
16		VccT	Module Receiver 3.3 V Supply
17		VeeT	Module Transmitter Ground	1
18	CML-I	TD+	Transmitter Non-Inverted Data Input
19	CML-I	TD-	Transmitter Inverted Data Input
20		VeeT	Module Transmitter Ground	1

SFP+ Module PIN Definition

Notes:

1. Module ground pins GND are isolated from the module case.

2. Shall be pulled up with 4.7K-10Kohms to a voltage between 3.15V and 3.45V on the host board.

订购信息

Part Number	Product Description
HD-SFP+/10G-CWDM-47-80	1470nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-49-80	1490nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-51-80	1510nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-53-80	1530nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-55-80	1550nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-57-80	1570nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-59-80	1590nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .
HD-SFP+/10G-CWDM-61-80	1610nm,CWDM 10Gbps, 80Km, SFP+ Transceiver -5ºC ~ +70ºC .