Product Description
Features
◆ Duplex LC connector Support up to 28Gb/s bit rates
◆ Hot-pluggable SFP footprint
◆ Built-in digital diagnostic functions
◆ Transmission distance up to 10 km on 9/125um SMF G.652
◆ Single power supply 3.3V
◆ RoHS6 compliant
◆ Operating temperature range Commercial :0℃ to 70℃ Industrial :-40℃ to 85℃
◆ Power consumption <1.2W
Applications
◆ Data Center
◆ 5GBASE-SR Ethernet
◆ 32G Fiber Channel Applications
◆ Servers, Switches, Storage and Host Card Adapters
Transmitter E-O Characteristics
Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
Support data rate | - | - | - | 28 | Gb/s | - |
Peak Wavelength | λp | 1295 | 1310 | 1325 | nm | 4 |
Spectral Width (-20dB) | Dl | - | - | 1 | nm | - |
Side Mode Suppression Ratio | SMSR | 30 |
|
| dB |
|
Average Optical Output Power | Po | -5 | - | 2 | dBm |
|
Extinction Ratio | Er | 3.5 | - | - | dB |
|
Transmitter and dispersion penalty | TDP |
|
| 3 | dB |
|
Output Power with Transmitter Disabled | Poff |
|
| -30 | dBm |
|
Transmitter Enable Voltage | VEN | -0.3 | - | 0.8 | V |
|
Transmitter Disable Voltage | VD | 2.0 | - | Vcc+0.3 | V |
|
Differential Data Input Swing | VINpp | 180 | - | 700 | mV |
|
Optical return loss tolerance |
|
|
| -12 | dB |
|
Output Eye Diagram | Compliant with IEEE 802.3 | 1 |
Receiver O-E Characteristics
Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
Support data rate | - | - | - | 28 | Gb/s | - |
Operate Wavelength | - | 1260 | - | 1360 | nm | - |
Receiver sensitivity in OMA | Sen | - | - | -12 | dBm | 2 |
Receiver sensitivity(BER of 1E-12) | Sen | - | - | -8.6 | dBm |
|
Saturation(BER of 1E-12) | Psat | 2 | - | - | dBm | 2 |
LOS Asserted | T_loss_on | -30 | - | - | dBm | High level: Alarm |
LOS De-Asserted | T_loss_off | - | - | -13 | dBm |
LOS Hysteresis | T_loss_Hs | 0.5 | - | 5.0 | dB |
Differential Data Output Swing | VOUTPP | 450 | - | 1050 | mV | - |
| LOS Low Voltage | VLout | - | - | 0.4 | V | - |
|
LOS High Voltage | VHout | 2.0 | - | - | V | - |
Notes:
1 At least 1000 waveforms acquired, with minimum 5% margin against 802.3 mask
2 Receiver sensitivity is measured with conformance test signal for BER=5x10-5.
Pin Definitions
Pin Diagram
Pin Descriptions
Pin# | Logic | Name | Function | Notes |
1 |
| VeeT | Transmitter Ground | - |
2 | LVTTL-O | TX Fault | Transmitter Fault Indication | Note 1 |
3 | LVTTL-I | TX Disable | Transmitter Disable | Note 2, Module disables on high or open |
4 | LVTTL-I | SDA | 2-wire Serial Interface Data Line (Same as MOD-DEF2 in INF-8074i) |
|
5 | LVTTL-I/O | SCL | 2 Wire Serial Interface Data Line (Same as MOD-DEF1 as defined in the INF-8074i) |
|
6 |
| MOD-ABS | Module Absent, Connected to VeeT or VeeR in the module. | Note 3 |
7 | LVTTL-I | RS0 | SFP+ RX Rate Select, optional | Rate Select 0, Not used. Note 9 |
8 | LVTTL-O | LOS | Loss of Signal | Note 4 |
9 | LVTTL-I | RS1 | SFP+ TX Rate Select, optional | Rate Select 1, Not used. Note 9 |
10 |
| VeeR | Receiver Ground | Note 5 |
11 |
| VeeR | Receiver Ground | Note 5 |
12 | CML-O | RD- | Inv. Received Data Out | Note 6 |
13 | CML-O | RD+ | Received Data Out | Note 6 |
14 |
| VeeR | Receiver Ground | Note 5 |
15 |
| VccR | Receiver Power | Note 7, 3.3V± 5% |
| Pin# | Logic | Name | Function | Notes |
|
16 |
| VccT | Transmitter Power | Note 7, 3.3V± 5% |
17 |
| VeeT | Transmitter Ground | Note 5 |
18 | CML-I | TD+ | Transmit Data In | Note 8 |
19 | CML-I | TD- | Inv. Transmit Data In | Note 8 |
20 |
| VeeT | Transmitter Ground | Note 5 |
Ordering Information
Part number | Product Description |
HD-SFP28/25G-LR | 25Gb/s 10km LR SFP28 Transceiver, LC, 10km, 0°C~+70°C With DDM |
HD-SFP28/25G-LR-I | 25Gb/s 10km LR SFP28 Transceiver, LC, 10km, -40°C~+85°C With DDM |